Make sure you insert the screw (attached to the spring-clip on the back of the light) into the hole on the inner body panel. Once you have the plastic fingers lined-up with the notch on the opposite side (relative to picture - above left), take your time and make sure the rubber gasket is seated properly as you push the assembly back into the fender opening - this is the trickiest part of the install! Push with moderate pressure until the metal clips secure the assembly. Inspect the outer edge of the installed light (picture - above right). Repeat steps for other light. Reinstall the wing-nuts on each light, then the circular plastic covers. Wha-lah!
|