[vettewagon]

What is the easiest way to get the motor mount into position. I just did a valve job/timing belt so on and having a bitch of a time getting the motor mount up and around the water pump pulley. I lowered the motor, raised the motor. Do I have to disconnect the driver side mount? Any suggestions? I cant believe I got this far and now this....

 

[jfoj]

I did not have much issue with the motor mount, however, I think things are easier with the lower dog bone disconnected.

 

[esse10]

motor mount

If you already bolted down the pulley then you did it wrong, they both need to go into position at the same time. You gonna have to remove the pulley out again, then put the mount into position but don't bolt it down, then you put the pulley in and bolt down and then the motor mount. Well that's how I did it and only lifted the motor up a little. Good luck man fyi I put those parts in from the top. Some folks are doing those from the bottom I believe.

 

[D2Beetle]

Perhaps this Thread Post might be helpful ...