VW Beetle Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
New member here, looks like a lot of good information on this site.
Frustrated with a p0715 code

Replaced input sensor, no change, tested wires from sensor to TCM, all OK. Replaced TCM, code cleared, shifted fine, got a P0864 which eventually cleared.

That was 5 months ago, now the P0715 is back, and stuck in limp mode.

Don't want to rip the dash apart again, sensor measured 900 ohms
out of the car.

I can clear the code and it comes back with the key on without starting or moving the car. Hoe does the code set without the tranny moving?

I am guessing something else is causing this, is there any way
to test the sensors? I don't want to spend money on parts that won't fix the problem.

2004 Beetle 2.0 gas, 01m automatic, 75,000 miles, replaced the tranny fluid and filter.

I am not a mechanic, but do my own repairs, this is my daughters car, and I don't have a Vagcom, any help would be appreciated, thanks.
 

·
Premium Member
Joined
·
3,453 Posts
Welcome to the great and wonderful ORG! Many fantastic cars, people and answers lurk in this great land. If you haven't done so already, take time to fill in your profile and thanks for posting a few photos so we can ORGle them!!

Cet a code reader - autozone or other. There are plenty of answers on the help sections - WELCOME AGAIN!
 
1 - 2 of 2 Posts
Top